Skip to content
GeoDataVision
Thread Options
#2267091 - 03/02/22 04:07 PM Joint intent placement on credit application
JoeG Offline
100 Club
Joined: Nov 2013
Posts: 124
DuPage county, IL
Our consumer applications have a separate section to evidence the acknowledgment joint intent when 2 people wish to apply jointly. Thus, if two people wish to apply jointly, they each initial this section stating they wish to do so.

Is there any thing in the regulations that prohibits us from placing this section which is for initials immediately below their signatures? Or must this be "joint section" be at the top of the application or just above their signatures? I was under the impression it could be placed anywhere, even on a separate page, as long as it is document at the time of application.

Return to Top
Fair Lending
#2267093 - 03/02/22 04:36 PM Re: Joint intent placement on credit application JoeG
John Burnett Offline
10K Club
John Burnett
Joined: Oct 2000
Posts: 39,793
Cape Cod
One key sentence in comment 7(d)(1)-3 to Regulation B applies:

"The method used to establish intent must be distinct from the means used by individuals to affirm the accuracy of information."

Apart from that, it should be on the application, rather than with it, to show that it was part of the application when the application was made. Putting the "intent" statement and initials (or signatures) at the top of the application sets it apart from the application signature to address that sentence quoted above from the comment. But there is no absolute rule on placement other than that sentence.

Ultimately, it is the lender's responsibility to obtain the intent to apply jointly documented at the time the application is made, assuming, of course, that the applicants do intend to apply jointly, wherever the joint intent section is. Where lenders mess up is when they go back and try to get the joint intent statement when the note is signed (or later).
_________________________
John S. Burnett
BankersOnline.com
Fighting for Compliance since 1976
Bankers' Threads User #8

Return to Top